PRODUCT FUNCTIONALITY
26
Chapter 7
PRODUCT FUNCTIONALITY
CONTROL BOARD
REMOTE CONTROL
SENSOR
D1 D2
1 D ON/OFF BUTTON
By pressing button 1 it is possible to switch the stove on and o automatically.
2-3 D WATER TEMPERATURE SETTING
Buttons 2 and 3 are used to adjust the water temperature which will then be distributed inside the plant.
4-5 D FUNCTIONING POWER
The power can be adjusted using buttons 4 and 5; the machine has 5 di erent powers
Display D1 to view the various messages.
Display D2 to view the power set.
CURRENT DATE AND TIME ADJUSTMENT
Follow the procedure below to adjust these parameters:
Remove and restore the stove power supply using the master switch or using the power supply 1.
cable.
The stove will rst display the microprocessor version, 2. “TIME”, then “LI 3” and then “OFF”.
When 3. “TIME” appears, press button 5 once to access the adjustment mode.
Display 4. D1 will show the current time, the hours ashing while the minutes are xed: use keys 2 and 3
to adjust the time and then con rm using key 5.
At this point the hours will become xed and the minutes will start to ash: use keys 2 and 3 to adjust 5.
the minutes.
To go back to selection of the hours, press button 4 again or escape and con rm using button 1.
gure 7.2
Comments to this Manuals