THE REMOTE CONTROL
30
Chapter 8
THE REMOTE CONTROL
The heating power, the plant set water and the automatic appliance ignition/switch o , can be adjusted
using the remote control.
To switch on the stove, simultaneously press buttons 3 and 5 for 1 second; the appliance will automatically
enter the ignition phase. The start phase will follow allowing the stove to develop and adjust the ame.
Once start phase is completed, the appliance enters normal functioning: it is possible to adjust the heating
power by using buttons 4 and 5, whereas the plant water temperature can be adjusted using buttons 2
and 3.
To switch o the stove simultaneously press buttons 3 and 5 for three seconds; display D1 will show
“OFF”.
The remote control works with a MN21 12 volt type battery (like open gates remote controls).
To replace the batteries open rear part lid as shown in the gures below.
S = Indicator light indicating the pressing of every
key.
Display keys correspondence with remote control
keys
1 = p3+p5
2 = p2
3 = p3
4 = p4
5 = p5
S
Open by pressing the point indicated in the gure
P3
P2
P4
P5
gure 8.1
gure 8.2 gure 8.3
Comments to this Manuals