Extraflame Comfort Plus User Manual download pdf (Page 19)

COMFORT PLUS INSTALLATION

Chapter 4

The air vent must be made outside the  ue as it must not suck heated air.

Fix the base using the locking screws.

Connect the conveyor pipe correctly to the piping for  ue evacuation, the air vent box to the relative intake

pipe and the conveyor to the ducting piping.

Re-position the machine body by repeating the operations carried out previously in the reverse order.

Finally, use the Allen wrench to turn the lockbolt anti-clockwise to block movement.

To understand whether the insert is correctly attached to the base, connect the plug to the socket: the

display should switch on.

The lower grill of the insert must lie at least 1 cm above the  re surface in covering

marble.

PEDESTAL ASSEMBLY OPTIONAL

Component description:

Comfort Plus 

Height-adjustable pedestal 

Lateral feed hopper 

Adjustable hopper support 

This type of installation can be used when there is no

base onto which the insert can be rested.

Proceed by positioning the base in the desired point

and use the feet to adjust the height (the bolts are

positioned in the four external sides of the pedestal in

the lower part).

Check the presence of a current socket on the rear of the

insert so that the socket is accessible once installation is

completed.

After having evaluated the correct position, the machine

body must be detached in order to  x the sliding base:

Use the supplied Allen wrench to turn the lockbolt 

clockwise.

Extract the insert 

Tilt it to release it from the rails. 

Fix the pedestal to the  oor using strong steel plugs

with a diameter of 8 mm.

Fix the base tot he frame using bolts.

Make a hole measuring 60 mm in correspondence with

the air intake.

 gure 4.4

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

No comments

Extraflame Comfort Plus User Manual Page 19